Bmi-racing Copperhead 12 Manuel d'utilisateur

You will need to secure battery with strapping tape. Congratulations, your done!Go to the starting setup sheet, adjust your car to the base setup and

Copperhead 12 1/12 Pro (LiPo) Racing Chassis Kit Includes:(1) #DBB1011R LiPo CHASSIS PLATE or (1) DBB1010R CHASSIS PLATE(1) #DBB1020R LOWER POD CF(1)

(1) #DBB2010 IRS LOWER SUSPENSION ARMS, SPACERS & SCREWS(1) #DBB2020 FRONT UPPER SUSPENSION ARM MOUNT SET(1) #DBB2025 UPPER SUSPENSION ARMS PAIR (

1. .050”, 1/16” and 3/32” Allen wrenches2. A #2 Phillips Screwdriver3. 3/16” and 11/32” nut drivers4. A pair of needle nose pliers5. A pair of slip jo

Front suspension assemblyLocate your lower front suspension arms and the hard anodized alloy pivot balls. Note that the arms are symmetrical. At thi

Step 6Attach the upper suspension arm assembly to the lower suspension arms as shown with 4-40 x ½” screws.Locate the left and right steering spindles

Step 10Locate four 8-32 x 5/8” screws and 4 nylon lower suspension arm spacer. Use 1 thin and 1 thick nylon spacer under each pad on the arms.Pass

Step 12Locate the delrin center pivot assembly, one 4-40 x ¼”, and two 4-40 x 3/8” flat head screws.Attach the center pivot assembly to the rear most

Step 16Locate the two alloy rear pod plates, the alloy rear pod plate spacer tube 2 4-40 x 3/8” flat head screws and 4 4-40 x ¼” flat head screws.Att

Step 201. Install the molded shock mount-antenna mount with 2 4-40 x 1/4” flat head screws using the 2 rear mounting holes.2. Assemble the Silva blad

Insert the IRS precision ride height adjuster cams into the rear alloy pod plates. Insert a 3/8” x ¼” flanged bearing into each ride height adjuster